Samurai Appliance Repair Man's Blog

In this journey into appliance repair enlightenment, Samurai Appliance Repair Man shows you how to use an airflow meter to analytically test the back pressure on a dryer vent for safety and efficiency. Looks can be deceiving, as this video shows, and even a short simple dryer vent that appears to be ideal can have airflow problems. So it's always wise to use a meter to actually measure the back pressure.



Here's the air flow tester I used in the video ==> http://www.repaircli...0106710/1447456




To learn more about your dryer or to order parts, click here.

from the service manual:

Main Top Removal
1. Disconnect power to cooktop.
2 Remove cooktop from installation position and place face down on protected surface.
3. Remove screws securing main top to burner box bottom.
4. Remove screws securing control panel box and conduit mounting plate to burner box assembly.
5. Remove main top.
6. Reverse procedure to reassemble, verifying that cooktop frame is properly aligned.
NOTE: Make sure the pieces of insulation, located in the front left and right rear corners,
are put back in place.
Failure to do so could create excessive cabinet temperatures.

Part link for the replacement burner ==> http://www.repaircli...mber=JEC0536ADB




To learn more about your cooktop or to order parts, click here.


Source: JennAir Glass Cook Top Model# JEC0536ADB, Replacing Burner, How to Remove Top?

If you have a newer model GE top-loading washer (GE's Hydrowave line of washers) and it inexplicably stops working, won't run at all, the problem may be as simple as needing to reset the control board. Very easy to do and no tools are required:




To learn more about your washer or to order parts, click here.


Source: GE Hydrawave Washer Motor Reset