Jump to content
Click here to check out our structured, online appliance repair training courses for rookies and experienced techs.

FAQs | Repair Videos | Academy | Newsletter | Contact


Samurai Appliance Repair Man's Blog

  • entries
    861
  • comments
    1,396
  • views
    2,681,666

How to replace the hall sensor in an LG front load washer


Samurai Appliance Repair Man

8,061 views

Remove the 4 screws on the rear access panel/remove panel.

Remove the 17mm bolt at the center of the ROTOR. Pull off ROTOR ASSY.

Remove the *phillips* screw that secures the wire harness to the rear of the tub.

Remove all of the bolts on the STATOR ASSY & carefully lower STATOR.

Unplug HALL EFFECT SENSOR.

Using a screwdriver or needle-nosed pliers---carefully bend the single locking tab of the HALL EFFECT SENSOR. Once pried/bent---the other three tabs will become disconnected.

Install new HALL EFFECT SENSOR. Carefully examine that *all* of the tabs are securely locked onto the STATOR ASSY.

Re-assemble & test washer.

Part link ==> Hall Sensor

Illustrative video:

Source: LG WM2277HW

0 Comments


Recommended Comments

There are no comments to display.

×
×
  • Create New...