Jump to content
Click here to check out this guide.

FAQs | Repair Videos | Academy | Newsletter | Contact


Samurai Appliance Repair Man's Blog

  • entries
    861
  • comments
    1,396
  • views
    2,681,515

How to get the error codes on an Electrolux dishwasher


Samurai Appliance Repair Man

6,817 views

Brother PDuff calls the dance steps on this little ditty:

Remove bottom access panel and check main control for any lit leds. Lit led is specific to affected component. Access Component/Relay/Triac test as follows:

From power up press Sanitize and Delay Start

"Et" should be displayed (engineering test)

Press Rinse Only

"rt" should be displayed indicating component test mode. Press the following buttons to toggle on/off each component:

Auto Sense-washer motor

Heavy-water valve

Normal-drain motor

Quick-drain valve

Rinse Only-Clean light led

Hi Temp-all leds on control housing

Sanitize-fan state

Air Dry-dispenser

When checking heater, always fill tub with water.

Source: Frigidaire D/W EIDW6105GB1

1 Comment


Recommended Comments

All you have to do to get error codes on an Electrolux is try to wash your dishes with the damn thing.

  • Like 1
Link to comment
×
×
  • Create New...