Jump to content
LIMITED TIME OFFER: Use code 10YEARS10 to get 10% off your Appliantology membership. Click here for more ×
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


Samurai Appliance Repair Man's Blog

A blog by Samurai Appliance Repair Man in General

  • entries
    862
  • comments
    1,398
  • views
    2,717,877

How to put a Maytag refrigerator with the ADC board into defrost mode

Samurai Appliance Repair Man

Entry posted by Samurai Appliance Repair Man

4,150 views

 Share

you may have the "newer" ADC Board

Posted 16 February 2012 - 12:33 PM

The "newer" Maytag ADC is a better design..

Newer OEM 61005988 (8-pin chip) 61005988 ADC Board... L1 (but NO Test pin)

Manual Defrost Cycle is tested by cycling the Freezer Cold Control 3x within 6 seconds and leaving it on MAX

click on picture

Defrost-Control-Board-61005988-00983681.jpg

The "older" style Maytag ADC (same part number)

This is the OLD (notice the 18-pin chip) 61005988 ADC failure-prone Board

It has the L1 - TEST (lower pins on connector)

Manual Defrost Cycle is tested by momentarily jumper L1 and TEST

(with insulated jumper)

00051420.jpg

Source: maytag defrost mode

 Share

0 Comments

Recommended Comments

There are no comments to display.

×
×
  • Create New...