Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


Search the Community

Showing results for tags 'spinning'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Appliantology Welcome Center
    • Site Orientation
    • Announcements
  • Professional Appliance Technician Forums
    • Appliance Repair Tech Forum
    • Master Samurai Tech Workshops
    • Samurai's Appliance Repair Video Classroom
    • Samurai’s Appliance Puzzles
    • The Dojo
  • Appliance Service Manual Requests
    • Appliance Service Manual Requests Forum
  • Appliance Repair Trade Resources
    • Looking for a Tech
    • Looking for a Job
    • Appliance Repair B2B Resources
  • DIYer Appliance Repair Forums
    • DIY Appliance Repair Help
    • Appliance Haikus

Blogs

  • Samurai Appliance Repair Man's Blog
  • kdog's Blog
  • Mrs. Samurai's Kitchen
  • DurhamAppliance's Blog
  • applianceman97's Blog
  • LI-NY Tech's Blog
  • tpoindexter's Blog
  • Eugene's blog about stores, fixing, life, and more!
  • Appliance Repair Tech Tips
  • Koi Guy's Amazing Compendium of Timeless Appliantological Wisdom

Categories

  • Appliance Repair Manual Stash Access File®
  • Appliance Repair Manual Pot Luck Supper

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Found 1 result

  1. AwesomeMarioFan

    MAV9750AWW Not Spinning

    Hello, We have a Maytag Atlantis MAV9750AWW, and we have been having a problem recently with the spin cycle. During the period of time before this happened, the washer would make lots of noise during the spin cycle and would "walk" around the room sometimes because of how off balance it was. The brake would also squeak after the spin cycle was ended. Now, the washer now agitates correctly, but will no longer spin or would spin very slowly. Upon disassembly the brake seemed to have been stuck engaged, since the pulley wheel would not disengage it when turning it counterclockwise but would agitate when being turned clockwise. When removing the brake the tub would spin freely, so we ruled out the bearings being the cause. We attempted to replace the snubber ring (old one was almost completely gone) and transmission pulley assembly in the unit. We were unable to finish installing the transmission pulley assembly because the included washer would not fit with the e-clip no matter how much we tried to raise the transmission shaft up (using flathead screwdriver). We were able to install it without the washer but it seemed to be very tight and even forcing the cam to turn to raise up would not disengage the brake. After messing around with the transmission some more we sort of gave up since we didn't want to replace the entire transmission and didn't have the bearing removal tool for the unit to remove it. It seems that the problem is that the brake will not disengage because the transmission is locked up? If anyone has any ideas please let me know. Also, if anyone knows where to get the special Maytag repair tools that would be great, since they don't seem to be available anymore. I have the washer's repair manual and can post it here if it would help out with repairing this problem. Thanks, - John
×
×
  • Create New...