Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


DISCLOSURE: We may earn a commission when you use one of our coupons/links to make a purchase.
  • Upcoming Events

    • 27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

microwave go BOOM


BrntToast

Recommended Posts

ive always wanted to try jumping out the fuse on a microwave and running it full of paint spray cans,  think it will go boom?

and yes this will be done at the end of a VERY long cord  :P

 

Link to comment
Share on other sites

  • Replies 11
  • Created
  • Last Reply

Try it with a can of that spray starter stuff.

Get it on film when you try, It could be a great show.

Nick

Link to comment
Share on other sites

 Put a cup of water in the microwave, and put a light bulb in the water, base down. Nice light show !!;)

Link to comment
Share on other sites

While we're at it, why don't we take a stainless steel bowl, fill it with gasoline and then start the microwave?

I think you guys lost your mind!

 

Sick minds think alike.:poison:

Link to comment
Share on other sites

How about a propane tank and a 30-06 rifle?

When I was stationed at Cherry Point Marine Air Station, someone blew up a phone booth with a claymore. It kinda roughed up the motel it was in front of.

Sweet.

Nick

Link to comment
Share on other sites

actually ive done a half full bbq tank with my 7.62x39  you have to light a fire around it a wait for the pressure relief to open right before you shoot it for the BIG boom, i had like 6 tanks at the time to play with and that way made the best actual explosion, the rest just shot flames out the bullet hole and spun in circles

this brings me to the decal i have on my 4x4,  its a redneck thing, you wouldn't understand....  but i'm sure most techs would   hehheeh

 

Link to comment
Share on other sites

for a cheap thrill take a water bottle, and fill it with acetalyne then screw cap on real tight, place aprox 25-30 meters from you and shoot with a .22 cal. will not flame but will turn bottle into schrapnel, and go BOOM.

Link to comment
Share on other sites

  • 4 weeks later...

:D well thats one thing to do with a microwave if your repair estimate hasnt been accepted by the customer-ill have to sell tickets ...how much money could i make??

regards mike:yikes:

Link to comment
Share on other sites

Sometimes the best are the accidentals. I was checking out a 25,000 btu ac and the hot burned out of the compressor casing. The line was arcing all over, there was a laaaarge fireball to start with then the freon put that out rather quickly but was still plenty enough to fill the shop with very thick black smoke that did roll from it like a mushroom cloud. In the dark (thick smoke blocking lights along ceiling) the light show from the still sparking hot wire was all the more impressive and was just enough to see the way to the breaker panel.

Link to comment
Share on other sites

  • 1 month later...

These would make popular clips on Youtube!! :coolblast:

Might get a few people arrested for acts of terrorism though!!! :yikes:

Old front panel PCB's from microwaves and VCR's with plenty of LED's and flouro displays look good cooked :)

TV power supply filter caps stuck in the end of a long extension lead are fun too (do this outside!!) :vinnie:

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.


×
×
  • Create New...