Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


DISCLOSURE: We may earn a commission when you use one of our coupons/links to make a purchase.

  • Upcoming Events

    • Appliantology Live Dojo, Saturday, 4/27/2024 @10 AM ET
      27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

Error code on whirlpool window ac unit

cfcitywide

By cfcitywide
in DIY Appliance Repair Help

Recommended Posts

cfcitywide

cfcitywide

Posted
Posted

Whirlpool model ACU124PM 220v window ac unit. Just recieved this unit from a customer. Applied power and fan comes on not the compressor. Went through some priliminaries and found nothing. I interuptted power and second time I get a EE on the display. Power was OK no spikes either. Single phase 234 volts at outlet. How can I check this board?

Is this board fused?

Link to comment
Share on other sites
  • Replies 3
  • Created
  • Last Reply
Cactus Bob

Cactus Bob

Posted
Posted

YOU CANT THAT WAY , IT DOES NOT HOLD CODES  , you have to back to basics . do you have 230v at compressor  between C-R ?  . is the overload open ? is the cap bad ?   do you here the relay click on the board when you call for cooling ?  did you remove the board and check the solder on the compressor relay ?   just normal troubleshooting stuff  . so shortcuts on this one    good luck

Link to comment
Share on other sites
cfcitywide

cfcitywide

Posted
  • Author
Posted

I can't get the control to respond to a call for anything. I assume the board is bad. Thought the board might be fused of have a reset. Compress ohms out fine.Thanks Cactus.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

Go to topic listing
×
×
  • Create New...