Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


  • Upcoming Events

    • 27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

Bosch WFMC 3200 Front Load Washer (WFMC3200UC/01)


Recommended Posts

  • Replies 11
  • Created
  • Last Reply

Top Posters In This Topic

  • RegUS_PatOff

    5

  • paltoii

    3

  • islamorada

    1

  • cmosh

    1

PM your email address ..

 

manual sent

Link to comment
Share on other sites

  • 8 months later...

Hi, I'm looking to replace a door gasket on our Bosch WFMC3200UC , it has a rip in it and is starting to leak. i purchased a gasket kit (door gasket, gasket holder and front/rear gasket clamps) the only instructions that came with it was a service bulletin which doesn't say much. if you can send me a service manual for this washer that would be great. i was planning on trying it this weekend.

thanks again

Link to comment
Share on other sites

Thanks for the service manual!

After looking at it, I'm almost ready to go but i just have question regarding the inner seal spring. I looked at the service manual but it doesn't mention anything about the removal of that one. I'm assuming it wraps around the drum or something. If any of you can suggest any tips regarding this inner seal spring before i start that would be greatly appreciated.

Thanks again!

Link to comment
Share on other sites

  • 1 month later...
  • 5 weeks later...
  • 3 months later...

Hi,

Could I get the link to the manual as well ?

I replaced the gasket on my washer but one of the clips inside of the door ended up falling into the door when I removed the hinge screws. Is there anyway to open up the door ?? Is there anything in the manual regarding this ?

Thanks,

Kim

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...