Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


  • Upcoming Events

    • 27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

Manual request for GE Profile PSC23SGRC SS


jcryanjr

Recommended Posts

Front water/ice dispenser just started being flaky.  Pulled cover and verified all  three connectors were seated and contact switch for cup lever is good.  Fridge is three years old with serial number HH416305.  Might be part of the muthaboard recall.

Looking to see if there are any diagnostics that I can run before doing battle with GE.

Thanks....

Link to comment
Share on other sites

  • Replies 2
  • Created
  • Last Reply

Top Posters In This Topic

  • jcryanjr

    2

  • RegUS_PatOff

    1

Top Posters In This Topic

Domo on the very fast response for the diagnostic codes.  I received a failure on 0-3, temperature control panel to dispenser board communication.  Everything else passed.

I have sent GE an email regarding the extended warranty coverage.  I'll keep my fingers crossed there and hope for success.

In the meantime, assuming GE treats me like a homebrew gone bad, should I look at replacing the dispenser board first, or the muthaboard to return full operation to the water/ice dispenser?

Many thanks.....

Link to comment
Share on other sites


×
×
  • Create New...