Jump to content
Click here to check out our structured, online appliance repair training courses for rookies and experienced techs.

FAQs | Repair Videos | Academy | Newsletter | Contact


  • Upcoming Events

    • 27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

Wascomat W74 Front Loader Service Manual


avdelgado

Recommended Posts

I have a W74 that I have taken out of service due to failed bearings.  Before I jump into this job that I will probably regret I would like to make sure that I have all the required pullers.  Thanks in advance.

Link to comment
Share on other sites

  • 5 months later...
  • Replies 1
  • Created
  • Last Reply

Top Posters In This Topic

  • Adirondack Bob

    1

  • avdelgado

    1

Popular Days

Top Posters In This Topic

Hello Andy, I have done quite a few of these. Wascomat has a complete tool kit with all the pullers that can be rented. Pretty sure its 100.00 dollars for 15 days. It also comes with detailed instructions. With the W74 you can find pullers at an auto parts store that will work. Also, we use 18 inch long car tailpipes to drive the bearings and seals back on. Just take the bearing and seals to auto store to match diameter.

Link to comment
Share on other sites


×
×
  • Create New...