Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


  • Upcoming Events

    • 27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

Asko Dishwasher 1805 Service Manual Request


ReliableApp

Recommended Posts

  • Replies 7
  • Created
  • Last Reply

Top Posters In This Topic

  • RegUS_PatOff

    3

  • ReliableApp

    3

  • Samurai Appliance Repair Man

    1

  • Darrell Robert Clevenger II

    1

[user=49422]ReliableApp[/user] wrote:

Red LED lights keep blinking ...
which lights ?
Link to comment
Share on other sites

The lights on the control panel/selector buttons:

There are 8 total. Sometimes its all 8 lights on the

 control panel and sometimes 4 of them flash with the other 4 staying on.

post-49422-129045112011_thumb.jpg

post-49422-129045112489_thumb.jpg

Link to comment
Share on other sites

FAULT INDICATIONS

L3 and L7 and display .F1. is blinking: Heating element fault.

L1-L8 and display .F2. is blinking: Overfill.

L4 and L5 and display .F3. is blinking: Sensor fault.

L6 and L7 and display .F4. is blinking: Water inlet fault. (Just machines with level sensor).

L1-L4 in sequence with L5-L8: The door is open during machine operation.

Link to comment
Share on other sites

It appears it could be

L1-L4 in sequence with L5-L8: The door is open during machine operation.

L1-L8 and display .F2. is blinking: Overfill.

But i'm having a hard time with this.

When the door is open the machine continues to run.  Water does not spray, just valve operation opening closing draining etc... is this normal?

Operation of the machine seems normal except for the mentioned above and very little water getting into machine.

Because of the inconsistency I was diagnosing this as the circuit board?? Now I dont know.  

Link to comment
Share on other sites

  • 7 years later...
  • Team Samurai
28 minutes ago, Darrell Robert Clevenger II said:

Looking for the tech manual or more information please.

Please start a new topic in this forum. 

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...