Jump to content
Click here to check out our structured, online appliance repair training courses for rookies and experienced techs.

FAQs | Repair Videos | Academy | Newsletter | Contact


  • Upcoming Events

    • Appliantology Live Dojo, Saturday, 4/27/2024 @10 AM ET
      27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

Fisher Paykel DD602

RVChaser

By RVChaser
in Appliance Service Manual Requests Forum

 Share

Recommended Posts

RVChaser

RVChaser

Posted
Posted

I recently removed my lower drawer to dry up water from a leak activating the float switch. After I put the drawer back in I now have no lighting for the handle LCD display. The unit chirps when you open the drawer and I have an light on the LCD on the touch pads(cycle pad). I even replaced the handle LCD from the top to make sure the Unit wasn't defective but had the same result. The bottom drawer worked fine before I removed it.

Link to comment
Share on other sites
  • Replies 3
  • Created
  • Last Reply

Top Posters In This Topic

  • RVChaser

    3

  • J5*

    1

Popular Days

Top Posters In This Topic

Popular Days

J5* Sensei

J5*

Posted
Posted

make sure that the display cable is connected correctly and plugged into the control unit ,

if you still have no joy then you have a fault control module

Link to comment
Share on other sites
RVChaser

RVChaser

Posted
  • Author
Posted

I plugged and replugged the connector numerous times thinking the same thing. I'm puzzled why the controller would go bad by just removing the drawer. I suppose I can swap the module from the drawer above for a test?

Link to comment
Share on other sites
 Share
Go to topic listing
×
×
  • Create New...