Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


  • Upcoming Events

    • 27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

Whirlpool Supreme GAs Dryer #LGR7848DQ1


sgilber

Recommended Posts

  • Replies 5
  • Created
  • Last Reply

Top Posters In This Topic

  • sgilber

    3

  • RegUS_PatOff

    2

  • appl.tech.29501

    1

Popular Days

Top Posters In This Topic

Thank you very much!!!

I have an open Thermal fuse. I jumped it and everything fires up fine.

I cleaned and vacuumed the entire unit, and will pick up a new fuse on tuesday.

Any other ideas why this opened?

Again, thanks very much....the small investment in your site is pricless!!!

Link to comment
Share on other sites

Check your vent system completely from the dryer lint filter housing all the way to the outside of the dwelling. A restricted vent is the # 1 cause for this fuse to blow.

Link to comment
Share on other sites

Dryer Vent

Vent should be rigid metal.

Short lengths of flexible metal may be OK, if not crimped when moving the Dryer into place.

NO plastic

NO PVC

NO screws

Foil Duct Tape is OK.

With an empty load, Timed Dry, High Heat, the vent temperature should cycle somewhere between 135F and 160F

Check / clean the Dryer Vent

Disconnect the Dryer Vent and check for good air-flow there and where it exits the house.

Check the Vent air temperature at the back of the Dryer.

If you have a Harbor Freight Store near you,

click on picture $ 4.99  sometimes on sale for $ 2.99

image_1255.jpg

Link to comment
Share on other sites


×
×
  • Create New...