Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


  • Upcoming Events

    • Appliantology Live Dojo, Saturday, 4/27/2024 @10 AM ET
      27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

EI26SS55GSO Electrolux SXS Fridge

Guest Repair_man

By Guest Repair_man
in Appliance Service Manual Requests Forum

 Share

Recommended Posts

Guest

Guest

Posted
Posted

Any one have a service manual for a EI26SS55GSO Electrolux SXS fridge ? I need to know how to get into diagnostic mode. Freezer temp going up and down and customer in panic mode over soft ice cream.

Link to comment
Share on other sites
  • Replies 3
  • Created
  • Last Reply

Top Posters In This Topic

  • RegUS_PatOff

    1

  • appl.tech.29501

    1

Popular Days

Top Posters In This Topic

Popular Days

appl.tech.29501 Sensei

appl.tech.29501

Posted
Posted

To get into diagnostics......

Press and hold the "freezer" temp. Up / down keys at same time for 5 seconds (if this has wave touch controls you must illuminate the display first).

All LEDs will light up...press the FF "up" key to clear the display...pressing the FF "up" key again will begin the first test

Display will show current test # in progress 1,2,3 etc. Pressing the ON/OFF key will turn off and on the particular load in the test...fan motor ,heater etc.

No key press in 5 min. Will exit the test mode

Order of tests.....

1) compressor

2) defrost htr.

3) FF lighting

8) water valve (dispenser only)

9) freezer lighting

10) auger motor

11) cube/crush solinoid

12) VCC condensor fan

15) Evaporator fan (toggle for "low" and "high" speeds

22) Damper test

23) FF door (OP=open / CL=closed)

24 Freezer door (OP=open /CL = closed)

26) Defrost limit switch (" ")

28) dispenser paddle test (press ON/OFF pad and press paddle with door. closed to test.

36) Ice door test (solinoid should activate when ON/OFF pressed freezer door should show ice door closed.

29) FF thermistor (press ON/OFF, "0"=good. ER = open/shorted

30)Freezer thermistor (" ")

33) Ambient Thermistor (" ")

34) Formware Version

38) VCC models only....compressor test

To exit diagnostics.....press and hold the "FF UP" key for 5 seconds...control will beep and test mode deactivates.

Link to comment
Share on other sites
 Share
Go to topic listing
×
×
  • Create New...