10 replies to this topic

[freespeech]

Complaint is that I am getting an F30 err code on oven. Wasn't sure if it was just temp prob or board anyone seen this?

[RegUS_PatOff]

F30 ERR
If the EOC detects that the oven temperature probe circuit is OPEN during the initial power up
you will not be able to program the time of day and the EOC will display “F30 ERR”
and the alarm will sound when you attempt to set the time.

http://www.repaircli...R=154&N=1015027

 

[freespeech]

Thanks reg. Sometimes the boards give me grief also.

[RegUS_PatOff]

Sensor $ 23
Controller $ 210

you do the math

[kdog]

These are resettable, they are wired in series with the sensor and trip out during self clean. Located close to the area where the probe harness passes through the liner at back of oven. If you reset it, it may (likely) trip again during next clean - has been an issue, have placed thin washers under mtg screws and instructed user to move range out a few inches prior to cleaning. This mostly 'cause I hate callbacks

[RegUS_PatOff]

These are resettable,

the Oven Sensor (thermistor) ?

[kdog]

Oops! forgot to paste the picture of the thermodisc there, will post it now ............

http://www.repaircli...R=154&N=1163680

 

[RegUS_PatOff]

F30 ERR
If the EOC detects that the oven temperature probe circuit is OPEN

[kdog]

Yes, the thermodisc is in series with the oven probe

[RegUS_PatOff]

ahh, yes, now I see it
I think I need my eyes checked again

[freespeech]

Replace temp probe and checked all tstats. Call went fine. Thank you all for your input.