Jump to content
Click here to check out our structured, online appliance repair training courses for rookies and experienced techs.

FAQs | Repair Videos | Academy | Newsletter | Contact


  • Upcoming Events

    • Appliantology Live Dojo, Saturday, 4/27/2024 @10 AM ET
      27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

Fisher & Paykel ED56 Dryer

Rapson

By Rapson
in Appliance Service Manual Requests Forum

 Share

Recommended Posts

Rapson

Rapson

Posted
Posted

Hi There,

I have a Fisher and Paykel ED56 dryer that does not seem to have adequate power to get the load started. The machine is about 6 years old. The motor, bearing, belts and pulleys all seem in very good condition. The unit only starts with very light loads. Heavier loads require a bit of assistance to 'get it going' - once its started it seems fine.

I've seen on other websites that this is a common problem, but have not found the solution. Can any one tell me what the problem is, I believe the motor is fine as once it gets going it operates OK and there is no noise as you would expect with a faulty bearing.

Can anyone send me a link for a service manual also.

Thanks

Link to comment
Share on other sites
  • Replies 1
  • Created
  • Last Reply

Top Posters In This Topic

  • J5*

    1

  • Rapson

    1

Popular Days

Top Posters In This Topic

Popular Days

J5* Sensei

J5*

Posted
Posted

the motor capacitor is bad

a very common and generic item

its job is to start the motor , hence why the motor is ok once running

and is ok with a light load

Link to comment
Share on other sites
 Share
Go to topic listing
×
×
  • Create New...