Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


DISCLOSURE: We may earn a commission when you use one of our coupons/links to make a purchase.
  • Upcoming Events

    • 27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

Kenmore dehumidifier 25358400890


ripple

Recommended Posts

I have a Kenmore dehumidifier model 25358400890

It is in my basement and I keep the humidistat at just below the half setting. It is an older analog dial not digital.

Sometimes the unit works fine, turning on and off correctly.

Other times it seems to get stuck and runs constantly and then the coil freezes over.

I turn the humidistat down and the unit turns off. I return it to the desired setting and again it will sometimes be fine, other times run and freeze.

Most recently I was gone for a few days and came home to 1 inch of ice on the coil. Not good.

What should I be looking to replace? Humidistat? What about the defrost thermostat?

Link to comment
Share on other sites

  • Replies 5
  • Created
  • Last Reply

... came home to 1 inch of ice on the coil.

... over the entire Coil ?

also, does the Fan run OK ?

Link to comment
Share on other sites

  • 2 weeks later...

I can't find a wiring diagram for that Frigidaire Kenmore model number

unless you have one you could scan & upload somewhere

then post the link here.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.


×
×
  • Create New...