Jump to content
LIMITED TIME OFFER: Use code 10YEARS10 to get 10% off your Appliantology membership. Click here for more ×
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


DISCLOSURE: We may earn a commission when you use one of our coupons/links to make a purchase.

  • Upcoming Events

    No upcoming events found

Tappan gas built in oven Mod. 12-3699-10

jambatt

By jambatt
in DIY Appliance Repair Help

 Share

Recommended Posts

jambatt Sensei

jambatt

Posted
Posted

Wires to ignitor had been shorted out by gas co. tech. Replaced ignitor but no response. Shorted out control board also. Control board no longer available. Owner sent board off to Canada for repair. Still no response from ignitor. No voltage at ignitor. Ignitor ohms out at about 174. Could gas valve be bad since they are wired in series. What should ohm value of gas valve be?

Link to comment
Share on other sites
  • Replies 2
  • Created
  • Last Reply

Top Posters In This Topic

  • RegUS_PatOff

    1

  • jambatt

    1

  • jumptrout

    1

Popular Days

Top Posters In This Topic

Popular Days

RegUS_PatOff Sensei

RegUS_PatOff

Posted
Posted

.... What should ohm value of gas valve be?

about 1 OHM

(3v @ 3A)

A short on the Ignitor circuit to chassis (ground) shouldn't cause the Gas Valve to blow,

unless the Wall Outlet polarity was reversed,

OR the Gas Co. "tech" shorted across the Ignitor, or applied 120v to Gas Valve. :woot:

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing
×
×
  • Create New...