Jump to content
Click here to check out our structured, online appliance repair training courses for rookies and experienced techs.

FAQs | Repair Videos | Academy | Newsletter | Contact


  • Upcoming Events

    • 27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

Whirlpool GU2300XTVQ Dishwasher, will not wash (pump not running) drains OK


mattmag

Recommended Posts

Hi there,

Need a service manual to perform diagnostics on this machine. It fills, will not wash, no noise from pump. Cancel/drain works fine.

Thanks--

-Matt

EDIT. OK it runs....*a little* sometime. Just tried it on "rinse only" cycle, pump ran about 2 seconds then shut off.......

Edited by mattmag
Link to comment
Share on other sites

  • Replies 2
  • Created
  • Last Reply

Top Posters In This Topic

  • mattmag

    2

  • RegUS_PatOff

    1

Top Posters In This Topic

Thanks much--- I'll run it through the diagnostics and see what happens. I'm a little concerned with the intermittent nature of this thing. I was hoping the pump was either a go or no-go, but I have found that it will run for a second or two at times, and others it won't start at all. I believe that would rule out a start capcitor?

Link to comment
Share on other sites


×
×
  • Create New...