Maytag Bravo washer model# loud roar during spin, tub bearing replacement
Posted 13 March 2012 - 05:58 PM
I've not had the honor and pleasure of doing one of these yet, praise be to the pot-bellied, buck-toothed, cross-eyed Buddha, but some of the other masters here have and may comment on this if the bowels so move them.
Posted 13 March 2012 - 06:03 PM
Or use this method: http://appliantology...-replace-guide/
And these Parts:
Need parts? Call our Parts Department now! 877-803-7957
Posted 14 March 2012 - 11:32 PM
Posted 20 March 2012 - 08:45 PM
Edited by Derik, 20 March 2012 - 08:46 PM.
Posted 20 March 2012 - 09:33 PM
No I didn't but how do you Copy and post pic on this site from a iPhone ???
Posted 20 March 2012 - 09:51 PM
Piece of pie, tovarish!
By the way, that preceding post that I just made was 100% dictated using a iPhone app called voice to app. Saves lots of time!
- kdog likes this
Posted 28 February 2013 - 08:14 PM
Posted 28 February 2013 - 09:09 PM
I have hammered on a few with a large hammer without having problems, sometimes the shafts are tough to drive up and out.
Posted 28 February 2013 - 11:04 PM
What was the model number..we got us another Bravos from tommytech...his model number did not compute.... possibly the same type of repair???.
Posted 01 March 2013 - 10:21 PM
As far the shaft as gone from being hit with a hammer.jpg 77.87KB 13 downloads Copy of inside of cabrio tub.jpg 98.14KB 15 downloads bottom side of Cabrio tub.jpg 112.28KB 13 downloads. it's like the shaft is catching somewhere. The thread part will go into the hole only so far and then stop. I'll take any input that I can. this shaft doesn't seem to want to go any further.
Hello, I started this job and waiting on parts. My question is that since I took off the nut on the bottom of the tub, I was able tap the shaft in to the point where the threads are no longer visible. This is far as I'm able to get the shaft to go. I've heard horror stories of the tub cracking from hitting it to hard. Any suggestions?
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users