Jump to content
Click here to check out our structured, online appliance repair training courses for rookies and experienced techs.

FAQs | Repair Videos | Academy | Newsletter | Contact


  • Upcoming Events

    • 27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

Kitchen Aid D/W KUDK02CRBS0


jambatt

Recommended Posts

kdog, can you try that download again?? Got the following message when I tried to download.

An Error Occurred

Sorry, an error occurred. If you are unsure on how to use a feature, or don't know why you got this error message, try looking through the help files for more information.

[#10870] We could not find the file specified

Link to comment
Share on other sites

None of the LED's will light up. New control board installed. Still no LED's. No response from touchpad. Put in diagnostic mode using instructions in tech sheet (OWI circuit). Still no response from touch pad. Unit starts, water enters, pump comes on and wash cycle starts. Have to turn off at circuit breaker. None of the touchpad buttons lightup or work. Electrical connections OK. Thermal fuse has continuity. Ribbons look OK. Could touchpad be completely dead or could it be something simple that I'm overlooking???

Link to comment
Share on other sites

# 1 . Console Assembly

# 2 . Ribbon Cable

# 5 . Interconnect Board

# 11 Electronic Control

all connected properly ?

W0510079-00002.png

Link to comment
Share on other sites

×
×
  • Create New...