Frigidaire LTF2140ES0 Won't Drain, Pump Out
Posted 12 April 2012 - 11:55 AM
Posted 12 April 2012 - 11:47 PM
Edited by zold, 13 April 2012 - 01:10 AM.
Posted 13 April 2012 - 01:47 AM
Also, according the the Mrs. the drain/spin option isn't working either.
Yep, no pumpy, not spinny, as explained in this podcast ==> Why won't a front load washer drain even after the pump filter has been cleaned out?
Drain pump part link ==> Drain Pump
Posted 20 April 2012 - 06:03 PM
Posted 20 April 2012 - 06:15 PM
Posted 20 April 2012 - 06:27 PM
Remove the drain pump.
Leave power wires attached.
Set the unit to spin.
Observe the pump impeller.
If it is rotating you have a blockage.
If you have power to the pump and it is not rotating,you have a bad pump.
I re-read your other post.
Is the machine spinning?
Posted 20 April 2012 - 08:10 PM
Posted 21 April 2012 - 11:26 AM
Posted 22 April 2012 - 10:37 PM
Posted 23 April 2012 - 12:15 PM
Door Switch - Black to Red/Blk - 121.4v
Door Lock - Grey to Red/Blk - 124.2v
Door Lock Aux Switch - Orange to Red/Blk - 121.6v
Wax Motor (???) - Pink to Red/Blk - 121.5v
I assume that this confirms the faulty door latch assembly prognosis?
Posted 23 April 2012 - 01:20 PM
I stuck my fingers up in the rubber boot, into the tub and didn't find any filters in my model. I can hear the pump running and if I put my hand on it, can feel it as well. Also, according the the Mrs. the drain/spin option isn't working either.
So, you needed the pump.
Now, with the new pump in, a follow-on problem is revealed. It's not common; yes it sucks, but it does happen.
At this point, now that we have the drain out working properly, and the no-high-speed-spin problem revealed, the problem will either be the door lock or the motor control board. You have been given good diagnostic info for the door latch.
Posted 23 April 2012 - 01:27 PM
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users