Need appliance parts? Call 877-803-7957 now or use the parts search box:

Parts Search

Learn appliance repair at online the Master Samurai Tech Academy.  Learn more.  Earn more.

FAQs | Repair Videos | Academy | Newsletter | Podcast | Contact

aragno

Fisher and Paykel DD605 LCD reads "34 min"

3 posts in this topic

I have a Fisher and Paykel DD605 (with LCD).

No matter which wash mode I select, it only says 34 min on the display. Even if adding the ECO mode, I get the same thing. I have unplugged and replugged in the washer and still the same problem.

I have pressed the start button and the machine locks the drawer and then beeps as if the wash is complete and reads "00" on the LCD display. Nothing more and nothing less.

The washing arm spins freely.

The bottom drawer is working perfectly well.

Anyone with some ideas?

Share this post


Link to post
Share on other sites

Need appliance parts? Call 877-803-7957 now!

Well now youre going to have using your diagnostic skills. Find the tech sheet (behind the lower drawer) and start taking measurements. The heater should show about 25 ohms each track. Thermister, about 12K at R.T Water valves about 65 each. Stator about 33 ohms from leg to leg. If every thing checks out well, try swapping the controllers from top to bottom and then the LCD badges. Good luck

Bob

coastalappliances.com

Share this post


Link to post
Share on other sites

sounds like a bad controller

swap them from top to bottom and see how you go

Share this post


Link to post
Share on other sites