Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


DISCLOSURE: We may earn a commission when you use one of our coupons/links to make a purchase.
  • Upcoming Events

    • 27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

RHEEM 12 Condenser Fan Overheated


L Ron Hoover

Recommended Posts

L Ron Hoover

Rheem 12 AC unit had the condenser fan stop. Evidently it the thermal cutoff was tripped. Reset and has yet to trip again. Current running 2.4-3.0 amps and spec states should be 2.0.

Possible causes? It was 102 degrees today here in Texas. I cleaned the housing off to ensure get air flow through the unit.

Do you think the motor needs replacing?

Link to comment
Share on other sites

  • Replies 2
  • Created
  • Last Reply

Top Posters In This Topic

  • RegUS_PatOff

    1

  • tommytech

    1

  • L Ron Hoover

    1

Top Posters In This Topic

unit model number may help

Fan Motor Capacitor may be bad

It's part of the Dual Capacitor.

With power removed, try turning the Fan Motor Shaft (or Blade) by hand.

Does it turn easily, smoothly ?

can you give it a spin, and it will continue for a few revolutions ?

Link to comment
Share on other sites

let the fan run for about 20 min,then check amp draw.if above rated draw inc. + /- %, i would replace motor and cap.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...