This was an evening right out of a horror movie! I was in another room and heard the ice dispensing out of the fridge, and dispensing, thought maybe a kid was trying to get ice and the dumb thing jammed and they werent thinking. Upon approaching the fridge, no human in sight and the light is flashing in the dispenser, it is beeping, ice is coming out of the ice side and water out of the water. I pull on them wondering how the **&^&* they could both be jammed, none of the control buttons will allow me to lock the control panel or do anything, just beeps at me. My mind is whirling, shut off the water but the ice dispenser will continue to "dispense" or run, and the machine will still have the "command" to dispense water. Open the door woman! I do and whew, relief for a moment...... I'm waiting at this point for some sort of paranormal being to come out of my refridgerator. I won't go into all my troubleshooting nightmare, suffice it to say I'd turned the electricity off to the unit at least 4 times waiting at least 20 minutes, left the freezer side door open to "thaw" incase something in the freezer door was frozen and wet?. Every time upon restart, within 15 minutes, it'd start beeping and dispensing both sides and the light wigging out. Finally I figure out how to get the dispenser cover off and unplug the control panel or whatever that computerized P.O.S. is. I was worried because you control temperature of fridge and freezer from there I'd be hosed and loose all my groceries. However upon unplugging everything continuted to run and get to proper temperature. So I have a temporary fix. I have a couple of options, replacing that board if that's the issue, closing her up and just grabbing ice out of the door, ( where I'm at right now) which is frustrating with a unit of barely three years. My largest question is upon unplugging the circut board I decided to unplug this other section thinking it was sending the message to the dispenser section in the door, so before I close up for temporary decision making should I re-plug that part in or does it send messages to the ( ice bin section) the part in question is two baby blue wires with an orange end that plug into a white end with a dark blue and white wire that channels into the main circut board plug. ( this is the one in the door) and am I risking any other controls by not replacing that circut board? I'm including a photo. The fridge is a kenmore elite 106.57869801. Thanks for any advice! We try to buy all our appliance parts / lawnmower etc. from you first in thanks for your wisdom!