Need appliance parts? Call 877-803-7957 now or use the parts search box:

Parts Search

Learn appliance repair at online the Master Samurai Tech Academy.  Learn more.  Earn more.

FAQs | Repair Videos | Academy | Newsletter | Podcast | Contact

  • Announcements

    • Samurai Appliance Repair Man

      ***READ THIS PRIOR TO STARTING A NEW TOPIC***   05/02/2016

      Topics with the complete and accurate model number in the topic title will get priority attention. You can validate your model number by entering into the form on this page: http://www.repairclinic.com/?clearLs=true For more help on using Appliantology effectively, please see this page:  
billpartsch

GE PFS22SISBSS Freezer Not Cold Enough

4 posts in this topic

Oh, Mighty Samurai:

Unfortunately, our home came with a GE PFS22SISBSS refrigerator, serial starting with AL. I replaced the muthaboard once already when the freezer temp went up to 15. (Tech checked the appliance, noticed fan wasn't spinning, said it was the board, ordered it, and then I installed the board myself and saved at least a hundred bucks. I didn't know then about the recall and don't know now if my unit would be covered.)

Now the freezer fluctuates daily between the low 20s and a smidge below zero. It makes ice and everything stays pretty frozen except the The refrigerator seems to stay in the 36-40 range. The fan is running. I replaced the two thermistors in the freezer. I checked the J2 plug today; both pin 3 to pin 5 and pin 3 to pin 8 came up at over 13vdc on a digital meter. (Maybe I didn't use it properly?) I also noticed that the compressor kicks on for a second or two and then conks out, as though it has forgotten what it meant to say. I've read around your forums, but alas, I am confused as to whether the problem is due to a defrost component, the compressor start relay, the muthaboard or what.

I'd appreciate it greatly if you could guide me on finding a diagnosis. Specifically, how do I use the multi meter to check for the appropriate symptoms, and where exactly on the appliance I should be placing each probe?

Thank you very much.

Share this post


Link to post
Share on other sites

Need appliance parts? Call 877-803-7957 now!

... PFS22SISBSS refrigerator, serial starting with AL.

... I replaced the muthaboard once already

... J2 plug today; both pin 3 to pin 5 and pin 3 to pin 8 came up at over 13vdc on a digital meter.

... also noticed that the compressor kicks on for a second or two and then conks out,

1) MB and Evaporator Fan would have been under recall

2) a bad Evaporator Fan can ruin the MB

3)

J2.3 Fan common / J2 pin 3 to pin 8 = 12 VDC

J2.5 Condenser fan / J2 pin 5 to pin 3 = 13.4 VDC

J2.8 Fan supply voltage

4) sounds like a bad Compressor Start Relay

may be your only problem

http://www.repairclinic.com/PartDetail/1265640

 

Start-Device-WR07X10097-00783308.jpg

Share this post


Link to post
Share on other sites

Thanks for the prompt response. I suspected the relay was the culprit, and I should find out by Thursday when the part should arrive.

1) MB and Evaporator Fan would have been under recall

2) a bad Evaporator Fan can ruin the MB

Does the above mean that badgering GE customer service won't get me free replacements anymore? Just curious, but if the relay doesn't remedy the situation, I may become more than just curious.

Share this post


Link to post
Share on other sites

I don't know, but the Relay could cause all of your current symptoms.

May depend if your serial number has been marked as a MB replacement in that recall.

Share this post


Link to post
Share on other sites