Edited by koobedo, 01 November 2012 - 11:38 AM.
fisher paykel DD605ss - U1 fill fault error
Posted 01 November 2012 - 09:41 AM
Posted 01 November 2012 - 05:40 PM
I've PMed you the service summary which has a list of action items for this fault and how to enter diagnostic mode.
- kdog likes this
Need parts? Call our Parts Department now! 877-803-7957
Posted 02 November 2012 - 09:49 PM
Posted 04 November 2012 - 04:06 PM
Swap the impeller between the drawers to check if the problem follows.
A split in the spray arm can also cause a fill fault by throwing the spray pressure (and thus pump load) off-kilter.
Posted 08 November 2012 - 01:28 PM
- swapped rotor
- swapped rinse arm
- swapped controller
DADoESTX, mentioned the fill level is sensed by the rotational load on the pump impeller. Is there a sender unit I need to look for? As it stands now, the top drawer stops at 113, 101, 94, 44, 38, and 14 minutes on the normal cycle and shows the U1 fault. I wonder if these times correlate to water fill point in the cycle.
Edited by koobedo, 08 November 2012 - 08:40 PM.
Posted 16 November 2012 - 05:53 PM
Posted 30 November 2012 - 03:29 AM
Well I got a hold of the nice people at F/P and they gave me an important bit of info,"the tub needs to fill in under 45 seconds". This wasn't happening and it was just taking too long to fill the tub. Replaced fill solenoid and all is well now. So turns out J5 was right with the flow rate check just needed to know what a descent rate was.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users