Jump to content
Click here to check out this guide.

FAQs | Repair Videos | Academy | Newsletter | Contact


  • Upcoming Events

    • 27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

Maytag stack set model # LSE7806ACE


abbinoxious

Recommended Posts

Fills with water to the correct level then stops. will not advance any further. We have replaced the timer & lid switch to no avail.

Link to comment
Share on other sites

sorry, I deleted your post in Laundry Appliance..

I thought it was a duplicate.

Does the Timer Motor advance ?

Link to comment
Share on other sites

... I believe it to be the lid switch. Husband says no.

I thought you said you replaced the Lid Switch (and Timer)..

just one or both Switches ?,

OR the Lid Switch Assembly ?

  • Like 1
Link to comment
Share on other sites

Simply put. The lid switch was replaced. My Question is could that switch be faulty or perhaps there is something less obvious that could be the culprit.

Link to comment
Share on other sites

just one or both Switches ?,

OR the Lid Switch Assembly ?

click on picture

Lid-Switch-Assembly-207166-00875878.jpg

click on picture

Lid-Switch-Assembly-208823-00576340.jpg

click on picture

Lid-Switch-Assembly-12001514-00892990.jpg

  • Like 1
Link to comment
Share on other sites

×
×
  • Create New...