Goodman HP package pops fuse
Posted 26 November 2012 - 11:42 PM
Posted 27 November 2012 - 12:07 AM
Posted 27 November 2012 - 07:54 AM
I suspect in the heat mode since you disconnected white.
In heat mode your low voltage components would be contactor,heat strips,and reversing valve while in defrost mode..
Amp each of these components to find out the draw while running normally.
You can jump the board to force a defrost to get the R/V to activate.
I suspect a bad reversing valve over-amping or a short in the R/V wiring.
Posted 27 November 2012 - 09:06 AM
(but I don't see a Fuse)
one of my video productions: “Easter Seals: Walk With Me”
every day is Down Syndrome Awareness Day
"A Child Is Waiting" . Burt Lancaster . Judy Garland . 1962
RegUS_PatOff > www.youtube.com/watch?v=oPAY2LsKVEw
Posted 29 November 2012 - 11:29 AM
Update-1st off YOU GUYS ROCK.....thanks for all your feedback, cuz I check it all. The fuse would blow when the unit shut down after a cycle or two, that suspect me to check anything that’s working at the end of the heating cycle. I know the T-stat wire was good, replaced all new. I checked each and every wire in the bundle and found a slit in the pink wire that comes from the HPS to the DFC-board. I also found several pinched wires as well. I also took out the heat strips from the circuit by disconnecting the Molex connector. I replaced the fuse, and let it run for 24 hours. So far so good. Now I going to install the strips back into the circuit and if the fuse blows, Its either the strips, or components and or the DFCB-Goodman says that board was just introduced this summer and this unit may had a early version of the board. Just for shits an giggles , I think I will change the contactor, cheap peace of mind.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users