if the compressor is a normal 120vac compressor and the start device is a normal PTC start device (not a 3ph inverter unit)
i would disconnect the compressors power wires and install a power cord to the start device just to test the compressor and the start device
run it for a while with the two plugins , makes sure it gets cold before going further
Thanks for the reply I hooked up the compressor straight to the wall and the device and the compressor run fine.
The file that Regus posted was the correct one. (thank you)
Am i right in assuming that on con1 pin 1 and pin 5 should have 120 volts when in test mode1?
In the pictures uploaded the white (Pin1) and yellow (pin5) wires, or board markings comp (Pin1) and L (Pin5)
Edited by KCTBURY, 02 December 2012 - 11:38 PM.