FAQs | Parts | Memberships | Repair Videos | Newsletter | Beer Fund | Contact
Welcome to Appliantology.org, the Web's Premiere Appliance Repair Resource for DIYers!
We have loads of repair manuals, photos, diagrams, personal instruction, and appliance parts-- everything you need to get it fixed and fixed right away!
You can post a question and get repair help for FREE! Click here to get started.
Already a member of the Appliantology Academy? Just sign in with your username and password in the upper right-hand corner of the screen.
Kohai
Posted 07 December 2012 - 02:54 PM
This Uline Ice Maker ULN-CLR60B-00 is overfilling the bin with ice leading to a wet floor. I spoke with my supplier and thought I ordered the right part (2756-S) but this looks like a thermistat.? I don't really know what I'm looking for or what a fill indicator really does or how it works or where its located. Does anybody have a service manual and or advice on the correct part? Thanks.
Uline.JPG 35.51KB
10 downloads
Sensei
Posted 07 December 2012 - 07:20 PM
Kohai
Posted 23 December 2012 - 08:56 PM
O.K. this Uline ice maker is kicking my arse. I replaced the circulation pump and the bin full thermistat. Everything worked fine for a few weeks, now its not producing ice, compessor is ice cold, no noises whats so ever. Checked for 120v at computer board and it appeared that there was power. The LED light wasn't on at all, then after moving stuff around it came on solid, but still nothing ran. I attempted to read the wiring diagram to see what to check, no luck. If I wanted to buy a bunch of parts to get this thing fixed would I buy a new board, on/off switch, start relay and overload? Thanks
Sensei
Posted 23 December 2012 - 11:32 PM
Sounds like there may be a loose connection ...
Is the Fuse on the Control Board good ?
When the Switch is set to "CLEAN", is there any activity ?
Kohai
Posted 24 December 2012 - 12:04 AM
Fuse on the board checked out good.
I switched to 'clean' and yes there is water activity.
loose connection? not sure.
Sensei
Posted 24 December 2012 - 12:15 AM
Looking at the wiring diagram, when in the ICE position,
try jumpering the Brown and the Black wires that go to the Control Board.
(that would by-pass the Switch and the Bin Thermostat)
or by-pass them separately
0 members, 0 guests, 0 anonymous users
FAQs | Parts | Memberships | Repair Videos | Newsletter | Beer Fund | Contact
Your Sometimes-Lucid Host:
"If I can't help you fix your appliance and make you 100% satisfied, I will come to your home and slice open my belly,
spilling my steaming entrails onto your floor."
ApplianceGuru.com | AppliancePartsResource.com | Fixitnow.com
Community Forum Software by IP.Board
Licensed to: Samurai Appliance Repair Man
