Maytag Front Load Washer Model# MAH22400AWW could use a service manual if available. All i know is that there is a '3E' error code, not sure what that is? Thanks,
Maytag Front Load MAH2400AWW with '3E' error code.
Posted 08 December 2012 - 08:57 PM
<<<'3E' error code, not sure what that is>>>
In most cases---a failed MAIN BOARD.
Doesn't hurt to verify that the HALL SENSOR and MOTOR are okay---before ordering new MAIN BOARD
L-O-N-G cycle times
Suds error message
Slow spin speeds
Intermittent water leaks (from rear of washer)
And other annoying symptoms which vary brand-to brand.
The *correct* amount of HE (High Efficiency) detergent that should be used in any front load or agitatorless top load washer with tub sizes 3.0 cu ft and larger is as follows:
HE: (2) Tablespoons Per Wash Load
HE 2X: (1) Tablespoon
HE 3X: (1) Teaspoon
Perform a TUB CLEAN CYCLE every (4) months.
Use: "Tide Washing Machine Cleaner"
Posted 08 December 2012 - 09:30 PM
one of my video productions: “Easter Seals: Walk With Me”
every day is Down Syndrome Awareness Day
"A Child Is Waiting" . Burt Lancaster . Judy Garland . 1962
RegUS_PatOff > www.youtube.com/watch?v=oPAY2LsKVEw
Posted 18 December 2012 - 10:32 PM
Well, I guess i'm not paying attention to your advice. I ordered a new board without checking the motor or hall sensor ( I have no idea what a hall sensor is? any explination would be appriciated), i put the new contol board in and it will fill, drain but will not spin or the drum will not turn at all. I can turn it manually, belt is hooked up. So in stead of looking at this post i ordered a new motor and door latch thinking it had to be one of the two, never thinking to investigate a hall sensor. How would i test the motor and hall sensor? Thanks.
Posted 19 December 2012 - 02:09 AM
Tach is internal to motor on this one - see page 11/12 of the second download (tech sheet)
- Samurai Appliance Repair Man likes this
Help us keep the lights on: buy appliance parts here ==> http://repairclinic.com
For service manuals and lots of other goodies, become an Apprentice ==> Apprenticeship
Posted 20 December 2012 - 05:13 AM
Thanks for the update, Alex.
Interestingly, the 3E failures in the 2400's apparently has the same cause and cure (replacing the motor) as in the 6700, 8700, and 9700 models:
- kdog likes this
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users