Need appliance parts? Call 877-803-7957 now or use the parts search box:

Parts Search

Learn appliance repair at online the Master Samurai Tech Academy.  Learn more.  Earn more.

FAQs | Repair Videos | Academy | Newsletter | Podcast | Contact

  • Announcements

    • Samurai Appliance Repair Man

      ***READ THIS PRIOR TO STARTING A NEW TOPIC***   05/02/2016

      Topics with the complete and accurate model number in the topic title will get priority attention. You can validate your model number by entering into the form on this page: http://www.repairclinic.com/?clearLs=true For more help on using Appliantology effectively, please see this page:  
AlexM

Maytag Front Load MAH2400AWW with '3E' error code.

7 posts in this topic

Maytag Front Load Washer Model# MAH22400AWW could use a service manual if available.  All i know is that there is a '3E' error code, not sure what that is?  Thanks,

Share this post


Link to post
Share on other sites

Need appliance parts? Call 877-803-7957 now!

<<<'3E' error code, not sure what that is>>>
 
***********************
 
In most cases---a failed MAIN BOARD.
 
Samsung-built unit.
 
Doesn't hurt to verify that the HALL SENSOR and MOTOR are okay---before ordering new MAIN BOARD

Share this post


Link to post
Share on other sites

Well,  I guess i'm not paying attention to your advice.  I ordered a new board without checking the motor or hall sensor ( I have no idea what a hall sensor is? any explination would be appriciated), i put the new contol board in and it will fill, drain but will not spin or the drum will not turn at all.  I can turn it manually, belt is hooked up.  So in stead of looking at this post i ordered a new motor and door latch thinking it had to be one of the two, never thinking to investigate a hall sensor.  How would i test the motor and hall sensor?  Thanks.

Share this post


Link to post
Share on other sites

Got the new motor installed today, and all good to go. thanks for all your help.

 

Drive-Motor-34001122-00660811.jpg

Edited by Samurai Appliance Repair Man
Added part link to motor.

Share this post


Link to post
Share on other sites

Thanks for the update, Alex.  

 

Interestingly, the 3E failures in the 2400's apparently has the same cause and cure (replacing the motor) as in the 6700, 8700, and 9700 models:

 

http://fixitnow.com/wp/2011/02/20/troubleshooting-the-e3-error-code-in-maytag-mah6700-mah8700-and-mah9700-washers/

Share this post


Link to post
Share on other sites