I have the Clean LED flashing 7 times. I pulled the heating element and it reads 10.2 ohms while the new one reads 11.7 ohms. It doesn't seem
to be enough difference to cause it not to heat up. Is this the problem or, should I look elsewhere? It faults out after resetting and won't cycle.
Shows the 7 flash Clean LED fault.
Decided to take a close look at the wiring underneath. Found an orange wire disconnected from a sensor in the bottom of the tub!
Guessing it's the water temperature sensor? I'll look it up later. I replaced the heater element anyway since I already had the dishwasher
pulled out. I'll update after cycling the dishwasher.
Edited by sparkydm, 28 December 2012 - 03:20 PM.