I have a ge profile that was having problems keeping the tempurature down. The condensor fan was running very slowly and the compressor would not start. Through some reasearch on past posts I narrowed the compressor problem down to a bad starter relay. I got good voltage readings at the j2 plug on the motherboard and assumed the condesor fan motor was bad as well. I went to a local parts store which had the relay in stock and ordered the fan motor. When I replaced the starter the condesor fired up and I used a small desk fan to cool the coils. The unit is working like a charm now, except...
The new fan motor has been installed and it still runs very slowly. I am getting 13.6v at j5 to j8 with the plug off and 13.6v at the fan motor connector with the fan attached and running.
Am I wrong in assuming the board is good?
How fast do these fans spin, it is spinning so slowly that I can count the rpm?
What are the odds the replacement unit is bad?
Any advise would be appreciated..