Need appliance parts? Call 877-803-7957 now or use the parts search box:

Parts Search

Learn appliance repair at online the Master Samurai Tech Academy.  Learn more.  Earn more.

FAQs | Repair Videos | Academy | Newsletter | Podcast | Contact

  • Announcements

    • Samurai Appliance Repair Man

      ***READ THIS PRIOR TO STARTING A NEW TOPIC***   05/02/2016

      Topics with the complete and accurate model number in the topic title will get priority attention. You can validate your model number by entering into the form on this page: http://www.repairclinic.com/?clearLs=true For more help on using Appliantology effectively, please see this page:  
gayle2c

Whirlpool LSW9245EQ agitator - basket misalignment

6 posts in this topic

My laundry is being shredded.  Not the dryer - the latest victims are table linens that have only gone through a soak and a wash cycle. 

 

There is an uneven gap between the bottom of the agitator and the inner basket.  Looking from the front of the washer, I have a 3/8" gap at 9:00 and a 3/4" gap at 3:00. 

 

When I remove the agitator, rotate it, and replace it onto the agitator shaft, the larger 3/4" gap remains at 3:00.

 

The washer agitates and spins as it should.  No alarming noises or leaks. 

 

Tho it seemed to me that it was an alignment problem, I started on the inside of the basket first.  The bottom of the agitator isn't warped; when I remove it, it's level and circular.  I've cleaned all the soap deposits on the agitator shaft and inner basket.  The 4 "buttons" on the shaft move freely in and out.

 

Once I remove the cabinet, where do I start looking? 

 

Thanks. 

 

Share this post


Link to post
Share on other sites

Need appliance parts? Call 877-803-7957 now!

Get more info here and pay close attention to the drive block

Share this post


Link to post
Share on other sites

Thank you both.  I'm traveling and will try this when I get back.

Share this post


Link to post
Share on other sites

So...I replaced the drive block, and replaced the agitator dogs while I was at it.  Still out of alignment - same gap, same place. 

 

But, I noticed that there was quite a bit of rust on one side of the agitator shaft.  I sanded it down, and the problem was fixed, albeit temporarily.  I know the agitator shaft and I guess the complete gearcase will need to be replaced next.  Hubby says no - get a new washer.  I say we'll see.  There's nothing on the market that I really want. 

 

Thanks.

Share this post


Link to post
Share on other sites

FIX IT! This washer will still outlast any of the new washers on the market today.

Share this post


Link to post
Share on other sites