This Danby Beverage Fridge Model# DBC2760BLS is not cooling. Both evaporator fans work well, the compressor and condenser fan not working. I put a hard start kit on and could only get it to start the compressor with a external 120v power cord, the it seemed to run fine. Is this as simple as replacing the relay and capacitor? Also, is this a Samsung? and does anybody have the service manual? Thanks
Danby Silhouette Beverage Fridge - no power to compressor
Posted 09 January 2013 - 11:18 AM
Is there 120 v. A.C. to the condenser fan and the compressor ???
Posted 09 January 2013 - 01:13 PM
Posted 09 January 2013 - 01:47 PM
do you have a tech sheet or wiring diagram you could post ?
one of my video productions: “Easter Seals: Walk With Me”
every day is Down Syndrome Awareness Day
"A Child Is Waiting" . Burt Lancaster . Judy Garland . 1962
RegUS_PatOff > www.youtube.com/watch?v=oPAY2LsKVEw
Posted 09 January 2013 - 03:06 PM
Does this unit have a two zone cooling capacity??? ................. two evap fans..................Is there an electronic board that runs the two zones????.....Hidden in the back, If I remember........
Posted 09 January 2013 - 06:06 PM
Sensei u right it does have 2 zones. those boards go bad also when 1 zone goes out (restriction etc) the 2nd zone will work for 24 hrs & then shut down ALSO.
Posted 09 January 2013 - 07:42 PM
Yes this does have the two fans, one in each compartment and no I didn't get my hands on a wiring diagram....
Posted 25 January 2013 - 01:37 PM
OK so i installed both control boards and main board P/N DG3-45, and new Start Relay P/N QP2-4.7, and new Overload P/N B99-125. I plugged the unit back in and all I get is a consistent beeping noise and flashing blue lights on the interior, its a quick beep, like one per second. I pressed the control buttons in various ways trying to reset the unit, didn't work. Did I get a bad board? is there something else I'm overlooking? Oh and the evaporator fans 'jump' but don't turn everytime the beep happens.
Posted 31 January 2013 - 08:45 AM
Sounds to me (JUST A GUESS) that you should put the old boards back in and see if the evaporator fans are still running normal. then I would check the power into the board, and check the power relay on the boar for the compressor, and condenser fan motor. there should be a wiring diagram some where on the unit. Try looking behind the kickplate, under the front of the unit too.
Insert smart ass remark here____
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users