Hello, I dont come here to bug you too often but I have a quick question regards to a "new" control board I purchased off Ebay (Yeah I know ) I purchased this board from Ebay and when recieved I could see the chicken scratches on the pins on the relays where you could see it had been at least installed. I got it for about 60 percent off the cheap price on the net so I could have forgiven that if they just installed it and it didnt fix the problem with the machine they were trying to fix and put it back in the box, but I installed it into my machine to see if it was used and put it into service mode and I saw the cycle count was 211. So it was used for a short time it appears, though 211 loads would not have been a long time, but why was it removed after this amount of time. So I check for codes set in memory and it says Code 6 Non-Vol.mem.err
That sounds pretty serious if it is a permanent error but I wanted to get your opinion. Should I send it back and get my money back or try to clear the codes and run it through a cycle in my machine? I cant find a copy of the 27 inch dryer repair manual for the Maytag Neptune MDG7500AWW anymore in the stash so I dont even know what that code represents.