Need appliance parts? Call 877-803-7957 now or use the parts search box:

Parts Search

Learn appliance repair at online the Master Samurai Tech Academy.  Learn more.  Earn more.

FAQs | Repair Videos | Academy | Newsletter | Podcast | Contact

  • Announcements

    • Samurai Appliance Repair Man

      ***READ THIS PRIOR TO STARTING A NEW TOPIC***   05/02/2016

      Topics with the complete and accurate model number in the topic title will get priority attention. You can validate your model number by entering into the form on this page: http://www.repairclinic.com/?clearLs=true For more help on using Appliantology effectively, please see this page:  
alamo3

Amana washer-topload model Lw9203w2

1 post in this topic

original problem unit stopped in middle of pump down and spin leaving 1/4 tub full of watewr and the board just showed two"dashes" or straight lines on screen. board would not clear or restart. checked lid switch for continuity in door closed position and it was good. unplugged at wall and plugged back unit still wouldnt start . ---ordered and installed the new board and now unit starts and fills and washes and agitates but as it counts down from 33 minutes of wash time it gets to 7 minutes and then indicator shows it has moved into spin but it doesnt pump down or spin it continues to agitate very slowly and at the 5 minute mark a screeching signal goes off and on the screen it shows what looks like  "rP" there is no error code key on the schematic paper-in fact im not sure it is an error code . when i clear and try restart it goes back to 7 minutes and repeats the same process described above. (stop 5 minute mark, alarm,error code) i tried to clear and pushed spin only (just to get the full tub of water out)   it shows spin and goes to 7 minutes but still no pump or spin and it repeats the old 5 minute stop screech error code scenario.  Totally confused any help appreciated.

Share this post


Link to post
Share on other sites

Need appliance parts? Call 877-803-7957 now!