Need appliance parts? Call 877-803-7957 now or use the parts search box:

Parts Search

Learn appliance repair at online the Master Samurai Tech Academy.  Learn more.  Earn more.

FAQs | Repair Videos | Academy | Newsletter | Podcast | Contact

  • Announcements

    • Samurai Appliance Repair Man

      ***READ THIS PRIOR TO STARTING A NEW TOPIC***   05/02/2016

      Topics with the complete and accurate model number in the topic title will get priority attention. You can validate your model number by entering into the form on this page: http://www.repairclinic.com/?clearLs=true For more help on using Appliantology effectively, please see this page:  
HUEY13414853

Whirlpool Model ED25TE not making ice

5 posts in this topic

My Whirlpool Model ED25TE Side by Side Refrigerator is not making ice. Anyone have any suggestions on troubleshooting and repair?

Share this post


Link to post
Share on other sites

Need appliance parts? Call 877-803-7957 now!

ED25TE

ED25TExxxxx

full model number ?

 

Is there Ice or water in the Ice Maker ?

Share this post


Link to post
Share on other sites

ED25TExxxxx

full model number ?

 

Is there Ice or water in the Ice Maker ?

 

Should be the modular style icemaker.  If no ice is in the mold, might have a bad water inlet valve or a frozen fill tube.  If ice is present, check that the shut off arm is completely down in the on position.  While looking at the icemaker from the front, the ejector rod fingers should be pointing to the 2 o'clock position.  If not, remove the motor cover and inspect the white drive gear.  Check the tabs at the center that lock the gear in place.  If tabs are damaged, replace module.  Inspect the icemaker mold coating for flaking or wear.  If flaking found, replace icemaker.  If all else is good, try to cycle icemaker by bypassing the icemaker thermostat.  Insert a jumper wire into test points T and H on the module.  Drive gear should begin to move clockwise.  Remove jumper wire after about 5-10 seconds.  Unit should call for water when the ejector rod fingers are at the 12 o'clock position.  If no water, check inlet valve for proper voltage and check fill tube for restriction.

Share this post


Link to post
Share on other sites

ED25TExxxxx

full model number ?

 

Is there Ice or water in the Ice Maker ?

Model may have a Fuse in the IceMaker wire Harness

If there is Ice, but it's not "harvesting", Freezer temperature may not be low enough

Share this post


Link to post
Share on other sites

Model may have a Fuse in the IceMaker wire Harness

If there is Ice, but it's not "harvesting", Freezer temperature may not be low enough

or a bad icemaker thermostat which would mean a new icemaker

Share this post


Link to post
Share on other sites