Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


  • Upcoming Events

    • 27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

Recommended Posts

I have visited this washer twice retrieving quarters out of the drain pump.   The complaint now is the clothes are coming out wet & owner thinks the spin cycle is not up to snuff.   May I have any & all manuals available for this beast?      Thank you.

Link to comment
Share on other sites

  • Replies 3
  • Created
  • Last Reply

Top Posters In This Topic

  • Patricio

    3

  • Spannerwrench

    1

Top Posters In This Topic

Replaced the pump this time,  Something took two of the 3 fins off the impellor, it was draining just taking too long so spin would not ramp up fully.

 

I put in service mode & I got a F2 code somewhere along service sequence.  Also dial cycle lights would not light in service mode, but light during cycle modes.      Machine working well thru normal, quick wash, & spin cycle.

Link to comment
Share on other sites


×
×
  • Create New...