Need appliance parts? Call 877-803-7957 now or use the parts search box:

Parts Search

Learn appliance repair at online the Master Samurai Tech Academy.  Learn more.  Earn more.

FAQs | Repair Videos | Academy | Newsletter | Podcast | Contact

  • Announcements

    • Samurai Appliance Repair Man

      ***READ THIS PRIOR TO STARTING A NEW TOPIC***   05/02/2016

      Topics with the complete and accurate model number in the topic title will get priority attention. You can validate your model number by entering into the form on this page: http://www.repairclinic.com/?clearLs=true For more help on using Appliantology effectively, please see this page:  
Unclewigging

Chest Freezer Stop Working. Kenmore 198.8183580. - help toubleshooting

5 posts in this topic

My trusty old Kenmore chest freezer stop cooling suddenly when my kid left the door ajar. I unplugged for a week and it wont turn back on. I hear a faint hum when I plug it in so i removed the access panel and see the compressor, start relay, and a capacitor. pretty simple layout.

how do i go about testing these parts? ohm/volt meter in hand. thanks.

Share this post


Link to post
Share on other sites

Need appliance parts? Call 877-803-7957 now!

one other thing. the compressor hums, doesnt start and then clicks off.

Share this post


Link to post
Share on other sites

seems like it's either a bad Compressor Start Relay

OR a bad Compressor

http://www.repairclinic.com/Kenmore-Freezer-Model-1988183580-ID-167416-Compressor-Sealed-System-Parts'

 

similar to Whirlpool EH150CXSW00   c.1987

 

You could check the OHMs between each of the Compressor pins ,,

OR make a Compressor Test Start Cord

Share this post


Link to post
Share on other sites

thanks... how do u test the start relay..... it clicks when i shake iit

Share this post


Link to post
Share on other sites

thanks... how do u test the start relay..... it clicks when i shake iit

 

 

The shake test is pretty reliable as long as it's used an a positive indicator only:  if it rattles when you shake it it's bad.  

 

But just because a relay doesn't shake doesn't mean it's good.  I've seen many relays pass the shake test but the resistance between the to plugs is too high to start the compressor.  

 

Typical is around 5 ohms, less than 10 ohm is still okay.  If you start seeing much more than this, then replace the relay:  http://www.repairclinic.com/PartDetail/Start-Relay/2262181/1026717?modelNumber=EH150CXSW00

 

Start-Relay-2262181-00783700.jpg

Share this post


Link to post
Share on other sites