My fairly new(just over 2 years old) washer seems to be stuck in a pause/cancel mode. It will power on, you can set a wash cycle and hold the start button, the door will lock and it will say "add a garment", no water goes into washer even though it counts back the numbers like it is running normal. It stops at 1 minute to go and will not unlock. I have to unlock manually. I ran a diagnostic and came up with F20 error code. I replaced the "pressure switch" and "inlet valve", still does the same thing! Please help!! I am in Florida, it's too hot to go to the laundry mat!! I am thinking about renting a washer until I fix mine!!
washer WFW9550WW00 won't run
Posted 10 August 2013 - 07:28 PM
Posted 11 August 2013 - 02:20 PM
Posted 12 August 2013 - 07:48 AM
Start a cycle and measure the voltage at the fill valves. If you're not getting 120vac there, then check the water valve wire harness connection at the CCU and check for the missing voltage at the other end of the harness at the CCU. If still no voltage, then replace the CCU: http://www.repaircli...ber=WFW9550WW00
Posted 19 August 2013 - 11:39 AM
P.S. The repair guy(who checked all the wires with an OHM meter) appeared clueless did get water to flow into the washer and drain. So, we know for sure it is not your typical water flow issue. Though washer did not agitate.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users