Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


  • Upcoming Events

    • 27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

Frigidaire refer...FSC23F7DSB7


certified tech group 51

Recommended Posts

  • Replies 2
  • Created
  • Last Reply

Top Posters In This Topic

  • RegUS_PatOff

    1

  • certified tech group 51

    1

  • tpoindexter

    1

Popular Days

Top Posters In This Topic

I've had 2 of these and in both cases it was a leak that had sprungs in the water filter. The water then would squirt through a small hole when water valve opened and get into the area with the board.

I remember thinking after finding the first one what were the chances that the filter could spring a leak in just the right place to shoot water through that little hole. Then damned if I didn't have another last year.

The first 1st took 2 boards cause when I got there they had taken the filter out and just told me they was going to replace it when they got a chance to pick one up. I noticed a very small amount of moisture in the tray with the board but didn't make the connection. Replaced the board and all was good. Got a call back couple of weeks later. They had put the filter back in to make ice, and it killed the new board.

The hole the water was going through was small and up toward the ceiling so it kinda amazed me that it even happen.

Then I had another, so, I suggest you consider the possibility and run some water checking filter for leaks before ya get it going and assume all it well.

Edited by tpoindexter
Link to comment
Share on other sites


×
×
  • Create New...