I have a Frigidaire GSTR1670aso. I have replaced the rear drum bearings twice now within a month. This makes me believe there is something causing bearing failure. What should I look for?
Washer eating rear drum bearings
Posted 16 November 2013 - 05:48 AM
No the spider and arm look good as far a corrosion there is some scoring where the shaft meets the spider
Posted 16 November 2013 - 12:49 PM
So you feel that its poor quality bearings? Not the inner tub/spyder arm-shaft
Posted 16 November 2013 - 03:02 PM
You're buying cheap, after-market bearings and they are failing rapidly because they are not machined to the exact tolerance required. At the RPMs and loads these bearings have to work, even the tiniest deviation from factory specs will cause premature failure.
What is the warranty on the after-market bearings you're buying? I think the answer to that question reveals much about their adherence to the tolerance specs.
Posted 16 November 2013 - 05:40 PM
Kicks major Samsung booty first, asks diagnostic questions later.
Posted 18 November 2013 - 09:57 PM
Reminds me of when I had a Ford Escort and I needed to replace the alternator on it. I tried to get by with a cheap aftermarket one instead of a genuine Ford Motorcraft alternator. The alternator only lasted one week. I had the auto parts store refund my money and went to my Ford dealer to buy the genuine Ford Motorcraft alternator. lesson learned.
- Samurai Appliance Repair Man likes this
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users