I put this unit in manual test, and it spins fine. When I retrieved the codes, I got the one for water level sensor, so I am thinking new board. Today I go and do the re-calibrate level sensor. Code goes away. I go to do an auto test, and when the detergent dispenser kicks in I get the dreaded f-1 code. I have read several post have some Ideas but wonder if anyone has had the same issue. I got it to ignore the F-1 and it went all the way through the auto test. Try it out and again when it starts up and goes into the phase where detergent is dispensed , F-1 appears, it reset and runs through cycle, but when it gets to final spin, now I have a wabblig basket.
Plan to go into basket, tub and do some cleaning. Just wondering if any one has more details on the F-1 and if they noted it occured during certian functions. I have checked the connections. I saw where Samurai did some handy sodering work on a board to make a better connection on a front load washer.
My line of trouble shooting thinking is that a water solinoid is causing over amps, or voltage draw on board, robing signal to other parts of circuit. Just thinking don't know for sure.