I have a Bosch SHE4AP06UC dishwasher that has been acting up lately. First what was happening is the wash cycles would stop short of finishing - primarily this was on the Power Scrub cycle. I have replace both control boards and am now on my second Timer / Power control board.
At the time I replaced the first Power Control board the problem went from some issue mainly with Power Wash - I found Auto Wash finished properly most times - to all cycles having problems.
If I put the original board back in this at least lets the Auto Wash run - but I prefer Power Wash due to the sanitizing.
OK _ SO now I have my Original Control board (behind the front panel) and the second Timer/Power (Base Mounted) board installed.
I downloaded the manual and ran the Self test - only allowed me to run the consumer version - start as soon as I hit < key - ant that shows results of Sanitized Light flashing and all others dark.
I ran the Power Wash cycle - which ended after only about 10 minutes - and when I requested the status code for that (using the > key) it again shows only Sanitized flashing.
So the problem I have now is two fold 1.) What is wrong with my dishwasher and 2,) I can not find this result in the manual I dowloaded - the manual references an SHE4AP12UC, but not he 06 like I have.
Any thoughts on what this might be? I am going to put my original board back in there tonight I think and see what that shows.
By the way - I am pretty dure based on the notes in the service manual and how hot the dishes were when the test finished - that the test all worked.
THanks for any suggestions.
Edited by DurhamAppliance, 17 April 2014 - 03:09 AM.
added model to topic title