Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


  • Upcoming Events

    • 27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

gas kitchenaid cooktop mod# KGCT305BAL0 ser# xg4101046


brm

Recommended Posts

Service Manual Request for a 4 burner gas  kitchenaid cooktop mod# KGCT305BAL0 ser# xg4101046. im having a hard time figuring out how to open the unit up i have tried using the 5 burner MODEL KGCT366E service manual #4317225 butt they are not same. thank you

Link to comment
Share on other sites

this cook top does not have screws in the burners, see attached.  so it looked like the bottom would be the access point but that does not come off either. it looks like the base is glued to glass top. if service manual is not available,  any suggestions I would appreciate. thank you

 

Link to comment
Share on other sites

this cook top does not have screws in the burners, see attached.  so it looked like the bottom would be the access point but that does not come off either. it looks like the base is glued to glass top. if service manual is not available,  any suggestions I would appreciate. thank you

 

Link to comment
Share on other sites

this cook top dos not have screws in burner. job aid 4317256 dos have screws. access is not from bottom, glass top so cannot hit burner top to free it to turn. unsure how to grab burner to turn it. afraid if i do get it to turn im going to twist gas lines. i hope there is a job aid for this mod# KGCT305BAL0 ser# xg4101046. thank you 

 

 

 

 

 

Link to comment
Share on other sites

I've ran into a couple that seemed to be glued. Idk if they were or if the hat just melted the seals. I used my razor knife to free the top but be careful not to brake it they break easily. Almost all the parts inside that thing are no longer available I would take that into consideration before I wasted a lot of time on it.

  • Like 1
Link to comment
Share on other sites

i wasted a lot of time on this one 25 min just to remove bottom.  the thing was very corroded together, leaving me to believe at first that the bottom did not come off. afraid of busting the glass top i used a plastic tool. and yup parts are on a 2 week back order. thank you

Link to comment
Share on other sites

×
×
  • Create New...