Jump to content
Click here to check out this guide.

FAQs | Repair Videos | Academy | Newsletter | Contact


  • Upcoming Events

    • 27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. 
      I'll be posting a couple more tech sheets before Saturday so be sure to follow this event to keep up with the tech sheets we'll be going through. 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

Kenmore DW 665.12093K210 Service Manual Request


MsAnn

Recommended Posts

  • Replies 4
  • Created
  • Last Reply

Top Posters In This Topic

  • MsAnn

    3

  • Samurai Appliance Repair Man

    1

  • DurhamAppliance

    1

Popular Days

I'm not having any luck,  maybe someone else has it. .... i hate searching for whirlpool made kenmore stuff  no good means to cross reference 

Edited by DurhamAppliance
Link to comment
Share on other sites

me either. Thanks Durham. I really need one, a  wiring diagram at least. I worked on this unit today and the soap dispenser solenoid kept energizing and de-energizing. With my lack of experience I did not know why it was doing this.  I could not test from the control without the diagram. I removed the wire connector and tested the solenoid for continuity and it was dead as a door nail. So like a big dumb ass I replaced the the soap dispenser (you cannot replace just the solenoid on this unit). Started that baby up and about 10 min into it the solenoid on the dispenser energized and got stuck. This horrible loud buzzing started and would not stop until I shut the power off.  I now know that it was getting constant voltage and the control board is bad. It was not a good moment when i had to go to client and tell them they now need a control board. I feel pretty stupid. If had only had the brains to know that both were bad I could have told the client. I feel like I failed them by not providing all the information they needed to make a sound decision about spending the money to repair both issues. Did I do a bad thing by replacing that soap dispenser without testing the control?  Should have I known that the control board was bad too? I told the client I would split the cost of the control board. Not a good day for Ms Ann. I almost cried. Not because of the money because I failed them. What is your thought?

Link to comment
Share on other sites

  • Team Samurai

Managed to salvage this one from the ash heaps of tech sheet literature: 

 

  • Like 1
Link to comment
Share on other sites

×
×
  • Create New...