Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


Search the Community

Showing results for tags '4306'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Appliantology Welcome Center
    • Site Orientation
    • Announcements
  • Professional Appliance Technician Forums
    • Appliance Repair Tech Forum
    • Master Samurai Tech Workshops
    • Samurai's Appliance Repair Video Classroom
    • Samurai’s Appliance Puzzles
    • The Dojo
  • Appliance Service Manual Requests
    • Appliance Service Manual Requests Forum
  • Appliance Repair Trade Resources
    • Looking for a Tech
    • Looking for a Job
    • Appliance Repair B2B Resources
  • DIYer Appliance Repair Forums
    • DIY Appliance Repair Help
    • Appliance Haikus

Blogs

  • Samurai Appliance Repair Man's Blog
  • kdog's Blog
  • Mrs. Samurai's Kitchen
  • DurhamAppliance's Blog
  • applianceman97's Blog
  • LI-NY Tech's Blog
  • tpoindexter's Blog
  • Eugene's blog about stores, fixing, life, and more!
  • Appliance Repair Tech Tips
  • Koi Guy's Amazing Compendium of Timeless Appliantological Wisdom

Categories

  • Appliance Repair Manual Stash Access File®
  • Appliance Repair Manual Pot Luck Supper

Calendars

  • Tech Training

Product Groups

  • Memberships

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Found 1 result

  1. The BOSCH SHU 4306 CU dishwasher (DW) is 20+ years young. It did develop very unpleasant behaviour. Any of the available wash cycle starts in correct way. These wash cycles are: POWER SCRUB PLUS, SCRUB WASH, REGULAR WASH, RINSE & HOLD. Here are step by step description of events. press ON switch the DW starts with the short drain sequence the DW starts with wash mode which was used in previous washing cycle water valve is enabled, water flows into the DW after while the big high pressure pump is activated and dishes are getting washed water continues to flow into the DW the safety floater starts to climb when it reaches the top point, the drain pump kicks in the water valve is disabled, water stops flowing into the DW in this moment, the water level is a little bit lower (see (9)) the safety floater goes down, the drain pump stops running the water valve gets enabled, the water is flowing again into the DW steps (7), (8), (9), (10), (11), (12) get repeated 15-25 times. Approximately once per second then, there is no cycling for approximately 15-20 seconds after these 15-20 seconds, the cycles 7-12 are again executed This goes for ever. If I interrupt the process, by simultaneously pressing POWER SCRUB PLUS and REGULAR WASH buttons, the DW goes into the DRAIN mode. All the water is pumped out from the DW and the CLEAN LED is activated. I did expect that at the end of the DRAIN process, the water valve will be disabled. But it isn't. The water continues to flow into the DW. Please, help out to debug and find the root cause for this unpleasant behaviour. Thanks
×
×
  • Create New...